view more31
Oct
AgFe vs. AgNi Electrical Contacts: Fine-Grain Microstructure for Low-Current ...AgFe (Silver-Iron) and AgNi (Silver-Nickel) electrical contact materials have different metallurgical characteristics that influence arc erosion, mate
view more01
Nov
SMD Surface-Mount Silver Contact Points for PCB Relays: Solderability and Tap...SMD electrical contact points for PCB relays must maintain solder-joint integrity, contact resistance, and dimensional stability throughout lead-free
view more28
Oct
Magnetic Circuit Optimization: Relay Pole Shoes and Yoke Geometry for Low-Pow...A low-power DC contactor targeting holding power below 0.5 W requires coordinated control of magnetic air gap, pole shoe geometry, yoke cross-section,
view more23
Oct
Dry Hydrogen Annealing vs. Vacuum Magnetic Annealing: Eliminating Coercivity ...Dry hydrogen magnetic annealing reduces residual stress, promotes grain growth, and removes interstitial carbon and nitrogen from suitable electrical
view more27
Oct
Vacuum Furnace Brazing of AgW and CuW Refractory Contacts in Heavy-Duty Air C...Silver-tungsten (AgW) and copper-tungsten (CuW) contacts are used in demanding switching applications where arc erosion resistance, thermal stability,
view more26
Oct
Ceramic-to-Metal Hermetic Brazing for 1000V+ EV Contactor Arc Chutes and Seal...For 1000V+ high-voltage direct-current (HVDC) contactors, a ceramic-to-metal joint must maintain electrical insulation, mechanical integrity, and gas
view more25
Oct
Inlay Clad Metal Strips vs. Cold-Headed Rivets: Optimizing High-Speed Switch ...For high-speed electrical switch production at 400+ strokes per minute (SPM), inlay clad metal strip can eliminate the individual rivet feeding and pl
view more24
Oct
AgZnO vs. AgSnO2 Contacts in AC-3 and AC-4 Motor Starters: High Inrush Curren...AgZnO (silver–zinc oxide) and AgSnO₂ (silver–tin oxide) are silver-based contact materials designed to balance electrical conductivity, ar
view more21
Oct
Metal Stamping Terminals and Current Shunt Assemblies for 12V/48V Automotive ...For 12V and 48V automotive start-stop batteries, terminal assemblies must withstand repeated cranking-current pulses, clamp loads, engine-bay vibratio
view more20
Oct
Extreme Marine and Desert Corrosion Protection for ESS Enclosures: C5-H Fluor...Outdoor energy storage system (ESS) enclosures installed on offshore islands and in desert photovoltaic plants face different but overlapping degradat
view more19
Oct
Arc Quenching Ceramic Chute Plates and Barriers for 1500V DC High-Speed Circu...At 1500V DC, arc interruption depends on rapidly increasing arc resistance, controlling plasma movement, and restoring dielectric strength across the
view more17
Oct
Moving and Stationary Copper Contacts for HVDC Relays: Silver Alloy Brazing &...For 800V DC contactors used in EV battery disconnect units (BDUs), the moving and stationary contacts must interrupt high DC without excessive arc ero
Send Inquiry





















